[Unknown]
Moderator: Moderators
-
SonyPortableizer
- Portablizer
- Posts: 1325
- Joined: Sun Jun 01, 2008 6:49 pm
- Contact:
[Unknown]
[Unknown]
Last edited by SonyPortableizer on Fri Nov 14, 2014 12:28 am, edited 1 time in total.
Re: Dire xbox help!!!
If R8A2 is missing it needs to be replaced as it's on the PWR_Enable line. It's a SMT 0402 100ohm Resistor and you can get it from plenty of online places, another 360 board or use any 100ohm Resistor that you can solder in there.
The more Ground/Power leads you have connected the better, unless you're using thicker wire than originally used.
The more Ground/Power leads you have connected the better, unless you're using thicker wire than originally used.
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.
Re-mappable Wireless 360 Controller - The CGnome
Re-mappable Wireless 360 Controller - The CGnome
-
SonyPortableizer
- Portablizer
- Posts: 1325
- Joined: Sun Jun 01, 2008 6:49 pm
- Contact:
Re: Dire xbox help!!!
http://www.radioshack.com/product/index ... Id=2062339
So these would be fine? Is there a way to put them in wrong?
So these would be fine? Is there a way to put them in wrong?
Re: Dire xbox help!!!
Those will work, provided you can solder it in place, and there are probably a million ways to install it the wrong way, but if you find a way to install a Resistor backwards be sure too let everyone know about it. 
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.
Re-mappable Wireless 360 Controller - The CGnome
Re-mappable Wireless 360 Controller - The CGnome