Snes-P

shmagoogin77 · Post by **shmagoogin77** » Sun Oct 09, 2005 9:24 am

electromaster64 wrote:
bioniclebert wrote:It runs off of 6AAs too. 4 go to the SNES and 6 go to the screen.
Wouldn't that create a problem by making the four batteries that go to both the screen and the SNES run down faster than the other two that go to only the screen??? I think it may work better to have all six go to the SNES and the screen, that way they all get equal power drain.

ya but the snes mini uses like almost zero power so

bioniclebert · Post by **bioniclebert** » Tue Oct 11, 2005 5:25 pm

Cart slot scheudeled* to arrive tomorrow. Hopefully afternoon will bring some life on this thing. *Thats how I spell it

Oh, and ive also found a little work to do, so If I'm not updatign, I'm getting moneys. All thats left to buy is a working PSone screen. Then I finish up the wiring, the casework, and Im set. The time finished will Most probably be before halloween, Assuming that this all works out.(just because Im waiting on the screen part)

Whats done?
The design
Controller = split
SNES mobo= hacked
Case= modded (very slightly)
Overall completion: 30%

shmagoogin77 · Post by **shmagoogin77** » Thu Oct 13, 2005 12:29 pm

sounds good
hope it all works out and you make lots of monies so you can buy that psone screen~~~~!!!!

bioniclebert · Post by **bioniclebert** » Thu Oct 13, 2005 1:11 pm

Yeah thanks

And heres the good thing. If the PSone screen Somehow say didnt work out, either I can make the case bigger or just have it flip down.

I'm sorry but hipgears are just a little small for a SNES portable, you know?

Post by **Triton** » Thu Oct 13, 2005 2:48 pm

have to disagree with ya there, my lcd is like 2.5 inches and is plenty big i think

bioniclebert · Post by **bioniclebert** » Sun Oct 16, 2005 5:58 pm

Got the cart slot! just got to wire it in. I have the wire to do it, so I need an opinion. Should I solder wires directly to the pins, or use a breadboard to have cleaner connections? The problem is, i'd have to wait a while to get the board. I could do it now without the board, but I believe that the wires will touch as they arent one solid wire.

electromaster64 · Post by **electromaster64** » Sun Oct 16, 2005 8:38 pm

Just solder them directly to the pins and then coat it in hot glue so they don't touch each other

xriverfalconx · Post by **xriverfalconx** » Sun Oct 16, 2005 9:25 pm

electromaster64 wrote:Just solder them directly to the pins and then coat it in hot glue so they don't touch each other

I concur!!! Much better that way!