WTB: Zenith Screen Gamecube A/V dongle

wallydawg · Post by **wallydawg** » Fri Jun 06, 2008 12:58 am

How stupid am I? When I bought a Zenith xbox screen from that fellow with the eBay store, I got the xbox one cause it was cheaper then the gamecube one (by a whole two dollars). The problem is that I don't even have an xbox to test the screen out on, so I need the gamecube a/v cable that came with it. This is the thing I'm talking about:

That's the xbox one of course, I need the GCN one. Hopefully someone has one of these left over from a project and will sell it to me cheap.

mothatrucka · Post by **mothatrucka** » Fri Jun 06, 2008 2:01 am

I don't have one, but if you have a GC cord, you can cut off the X-Box end, match the wires, and put the GC end on that same cord.

wallydawg · Post by **wallydawg** » Thu Jun 12, 2008 7:11 pm

wallydawg · Post by **wallydawg** » Sun Jan 04, 2009 11:08 pm

necrobump, while I now do own an xbox, I still want one of these to use on my gc and snes while still being able to use it on the xbox. With an influx of people making a new stuff and all that hopefully someone has one

schmellyfart · Post by **schmellyfart** » Mon Jan 05, 2009 12:09 am

The Zenith Gamecube screens dont have that attachment. The cablees are soldered directly to the board.

Well, at least mine are.

Ben Cebhrem · Post by **Ben Cebhrem** » Mon Jan 05, 2009 12:38 am

If you open up the dongle, the wire codes (for me at least) are:

Blue Audio Left
Red Audio Right
Brown Composite Video
Black and bare are ground and shield (really? what's the point?) respectively.

Wire it up to an AV switch directly, and you should have no problems using the Zenith screen for any system that outputs composite video. I found an el cheapo AV switch at Big Lots recently for about $5.