Help with joystick

soxinrevin · Post by **soxinrevin** » Sun Feb 25, 2007 1:36 pm

Im wiring the n64 joystick directly to the controller chip and i ran into a problem.
On the chip the is only 5 connections but on my joystick the is six wires.
im using this picture on where to wire them on the chip
Here:

Kyosho · Post by **Kyosho** » Sun Feb 25, 2007 2:44 pm

This is probably extremely stupid of me to say as I'm sure you've considered it or whatever, but perhaps number 6 is ground?

soxinrevin · Post by **soxinrevin** » Sun Feb 25, 2007 2:51 pm

Kyosho wrote:This is probably extremely stupid of me to say as I'm sure you've considered it or whatever, but perhaps number 6 is ground?

I thought of this but I'm not sure because there are 5 grey wires and 1 white

ShockSlayer · Post by **ShockSlayer** » Sun Feb 25, 2007 2:53 pm

Connect the white one to grounds.

SS

soxinrevin · Post by **soxinrevin** » Sun Feb 25, 2007 3:00 pm

ShockSlayer wrote:Connect the white one to grounds.

SS

OK i hope your right
Thanks

Jongamer · Post by **Jongamer** » Sun Feb 25, 2007 4:03 pm

Or Get a Multimeter, thats what Ive always been told yet still dont have one.

Thegamer3000 · Post by **Thegamer3000** » Mon Feb 26, 2007 1:32 pm

there are some other componets it looks like your missing if you completely cut the board. But maybe you've thought of that.