can my portable run on...

vgcollector666 · Post by **vgcollector666** » Sun Mar 19, 2006 3:49 pm

Can I run both the PS1 Screen and the actual portable on a single 7.2v battery?

Post by **CronoTriggerfan** » Sun Mar 19, 2006 3:52 pm

Yes. You just have to wire the power spot on the PSOne board to the spot on your NES board where your regulator used to be (does the NES use a 7805? If so, then it's okay. I don't know about other regulators, but I'd assume it's the same). After that, wire the DC power for NES board and DC power for PSOne screen to a switch/connector to the battery pack. Hope this helped.

CronoTriggerfan

vgcollector666 · Post by **vgcollector666** » Sun Mar 19, 2006 3:54 pm

I kinda understand that but I am a very visual person, do you think you could draw up a diagram for me?

Post by **CronoTriggerfan** » Sun Mar 19, 2006 3:57 pm

I may be able to, if I can host such a large file. What are you using (NOAC, Super Joy, Yobo, NES original

, etc.)?

vgcollector666 · Post by **vgcollector666** » Sun Mar 19, 2006 4:07 pm

I am going to be using a Yobo

Post by **Skyone** » Sun Mar 19, 2006 4:35 pm

Then ya, you can run 7.2 on both, easily.

Klefmung · Post by **Klefmung** » Sun Mar 19, 2006 8:26 pm

Yobo is my personal favorite, so good luck. Mainly because the pinouts are written there rather than me having to do the dirty work (Which I actually did before I figured out they were written. >_<)