Hip gear audio amp-Simple hookup

bioniclebert · Post by **bioniclebert** » Fri Mar 10, 2006 8:29 pm

OK, I've dissected my NES portable, and I've found the audio amp. There are 3 wires going into the section I have. Those three are Audio, Ground, and 5V. Hopefully When I get home I can further explain exacty where to hook this up, and include pictures.

Basically, all you do Is cut it off right after the audio Pot. Then COnnect the audio lines as normal (the red and white wires).

Then, Scrape/sand off Two leads near the pot. 1 is 5V, and the other is ground. I think I'l be able to explain this a bit better when I'm back.

By doing it this way, Its simple to connect, and it leaves the original audio pot and heaphone jack without a lot of rewiring.

Website · Post by **Life of Brian** » Sat Mar 11, 2006 4:54 pm

That would be awesome if you'd post pics - you've got just the info I need right now

bioniclebert · Post by **bioniclebert** » Sat Mar 11, 2006 7:37 pm

Dang, I need a picture of the area of the audio amp.
If somebody could provide the picture I can show where to cut and rewire.

G-force · Post by **G-force** » Tue Mar 14, 2006 2:10 pm

I can scan my Hip Gear adjust board later. Hopefully imageshack will allow me to upload it (it's a female of the dog species to me).

bioniclebert · Post by **bioniclebert** » Tue Mar 14, 2006 2:15 pm

G-force wrote:I can scan my Hip Gear adjust board later. Hopefully imageshack will allow me to upload it (it's a Finster to me).

THANK YOU!

G-force · Post by **G-force** » Tue Mar 14, 2006 8:36 pm

lol, after spending about 10 minutes scanning and resizing, I found a pic of the amp I used for my NESp. Is this pretty much what you did?

And here are the scans of the board.

bioniclebert · Post by **bioniclebert** » Wed Mar 15, 2006 1:48 pm

yes, the first picture is exactly how to do it. Thanks!

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Wed Mar 15, 2006 4:26 pm

great info!!! now i may be able to get my amp working. Thanks guys

Website · Post by **Life of Brian** » Thu Mar 16, 2006 7:52 am

Thank you, guys!