hipgear volume to the gameboy volume???

The Hacker · Post by **The Hacker** » Thu Aug 11, 2005 6:33 pm

how do i connect the hipgear volume to the gameboy volume
after i cut the hipgear controller bored off?
like what G-force did with his NES p0cket

usbcd36 · Post by **usbcd36** » Thu Aug 11, 2005 6:35 pm

Well, if G-force could do it, the pots are probably the same value. Just make yourself a custom board. I think the schematics for it are around here somewhereâ€¦

The Hacker · Post by **The Hacker** » Thu Aug 11, 2005 6:54 pm

i cant see this

The Hacker · Post by **The Hacker** » Thu Aug 11, 2005 7:14 pm

someone help me

daguuy · Post by **daguuy** » Thu Aug 11, 2005 7:19 pm

if the pots are the same value, desolder the one on the hip gear and solder it to the coresponding pins on the gameboy's pot

G-force · Post by **G-force** » Thu Aug 11, 2005 7:21 pm

Okay I will have a pic of what to do when I get the page up. But until then, mess with the multimeter and try to figure it out.

This should help you a bit, if you are looking at it from the side (the gameboy rotated 90 degress left) and face on, the pinout is like this:
(you will see 5 pins sticking up from the pot)

pin 1 is Ground, pin 2 is not used, pin 3 is audio in from the Hip Gear amp, pin 4 is audio out to the Hip Gear amp.

And then you just replace the Hip Gear sound pot with the GB one

The Hacker · Post by **The Hacker** » Thu Aug 11, 2005 7:31 pm

thank you but i'm not sure i get it how soon will you get the pic

G-force · Post by **G-force** » Thu Aug 11, 2005 7:42 pm

Probably not for a while yet. I've been really sick and I have been busy making a better site for all my stuff. I would guess 2-3 weeks and it will be done.

The Hacker · Post by **The Hacker** » Thu Aug 11, 2005 8:29 pm

im sorry
get well soon