psone + genesis 2 = no audio?

myname2 · Post by **myname2** » Thu Jun 28, 2007 12:07 am

Soo.. I have a thread in the genesis forum, and I need help.

I have the composite and ground hooked up, video works fine.

My audio is the problem, I have right audio on pin 2 and left audio on pin 3, and both grounds hooked up ( all of this is slot two)

On the genesis end, right audio is on pin 9, and left audio on pin 8, and its grounded.

Soo.. Any ideas why I can't hear anything?

Post by **CronoTriggerfan** » Thu Jun 28, 2007 10:12 am

Did you jump the headphone pins on the back of the PSOne screen motherboard? You need to do that to get audio from anything but the PSOne. I believe they're labeled HP-1 HP-2 and HP-3...

CTFan

myname2 · Post by **myname2** » Thu Jun 28, 2007 10:22 am

Thankyou. Those are the ones near the bottom by where you can input the video and audio right?

And I'm assuming I can just put a glob of solder across them?

I think that should be in the screen info sticky haha.

bmire1985 · Post by **bmire1985** » Thu Jun 28, 2007 1:03 pm

myname2 wrote:Thankyou. Those are the ones near the bottom by where you can input the video and audio right?

And I'm assuming I can just put a glob of solder across them?

I think that should be in the screen info sticky haha.

You are correct I believe it is in the sticky somewhere if not it is definitely in the ben's book