It would seem like one of the lines for the X button goes to one of the chips' little half-circle indentations, but no pin. The line is on the left side of the chip in the lower middle of the second diagram, page 243. So which pin does it go to (it would probably be easiest to understand if put into .jpeg form, or some other picture) ?
Also, it's no problem for me, but in the first diagram on the same page, it would appear that the left button doesn't connect to the ground. I actually didn't even notice this until I had already set up my own little diagram, with said problem not even there.
error on page 243?
Moderator: Moderators
-
Super Mulletman
- Posts: 390
- Joined: Sun Apr 18, 2004 12:17 pm
- Location: Wherever my orders let me be
- Contact:
-
Kayleigh57020
- Posts: 5
- Joined: Wed Dec 28, 2005 7:37 am
- Contact:
ROFL
"button" is insanity.Super Mulletman wrote:It would seem like one of the lines for the X button goes to one of the chips' little half-circle indentations, but no pin.
-
Unidentified Assilant
- Senior Member
- Posts: 2531
- Joined: Thu Oct 21, 2004 12:26 pm
- Location: Yea I like machine head
