ok so i decied to build my on case

striderx · Post by **striderx** » Tue Aug 23, 2005 5:05 pm

ok so i decied to build my on case from scratch not vaccuming so how do i determind what kind of screws, how many screws and nuts, the sizes of the screws and nuts ill need, and how many do i need

Xorealix · Post by **Xorealix** » Tue Aug 23, 2005 6:38 pm

I'm no case expert, but I gather that screws and nuts are the least of your problems.

First, worry about things like materials, size, shape, etc. Draw a design for the case using exact measurements- then decide where to place screw holes and the like.

daguuy · Post by **daguuy** » Tue Aug 23, 2005 8:02 pm

size of screws is very easy. just find a size that's not too big to fit in what you're screwing it too. just drill a narrow hole (no bigger than the size of the screw shaft) and screw a screw into it