eMachine...GRR

HotDog-Cart · Post by **HotDog-Cart** » Mon Jul 18, 2005 7:44 am

hey i have emachine and its workin good but 2 things, the first one is
ITs mesurements are way OFF! it say like 8" (inch)
is like 6-8cm and since iits measurements are OFF by a long shot, its very confusing!!

#2(is 8 inch, like this 8" or 8'??)

BloodNess · Post by **BloodNess** » Mon Jul 18, 2005 8:21 am

8"=inches

8'=feet

HotDog-Cart · Post by **HotDog-Cart** » Mon Jul 18, 2005 9:59 am

ok but emachine is stil way off

Post by **SpongeBuell** » Mon Jul 18, 2005 10:03 am

does that really matter? As long as it's working fine, I don't really care.

HotDog-Cart · Post by **HotDog-Cart** » Mon Jul 18, 2005 10:05 am

well it just confuses me when i measure stuff but ya it works

Post by **gannon** » Mon Jul 18, 2005 11:01 am

are you sure you're just not switching the measurement scales (which IIRC will keep the length at the same digit)

HotDog-Cart · Post by **HotDog-Cart** » Mon Jul 18, 2005 11:51 am

i dont get what you mean gannon, i just used the measurement defaults that came with Emachine Shop

its says this <-------------------------------------------------------> is 7"

Post by **SpongeBuell** » Mon Jul 18, 2005 1:17 pm

wait a minute, I thought you were talking about Emachine computers, not emachine shop. Try zooming in or out.

nos_slived · Post by **nos_slived** » Mon Jul 18, 2005 10:10 pm

Go into settings and switch from cm to inches, and use 8 as you input, not 8".