can anyone help me on xbox 360 RROD??

[N64BitModder]

i have done the 360 x-clamp trick but it did not work. In matter of fact i think i made it worse , ugh can anyone out there help me?

[bassmasta]

http://forums.benheck.com/viewtopic.php?f=39&t=37169" onclick="window.open(this.href);return false;

[humakabula1]

get the secondary code and post back with that.

[N64BitModder]

for the secondary code the lights blinked 4243 and i guess it means 0203

[Xbox Scene]
E35: over heating GPU possibly due to lack of thermal compound.

does that help?

[bassmasta]

Did you leave the stock heat compound on there? If you did, take off the heatsink and clean off the GPU with some ~95% isopropyl alcohol and some q-tips (I found toothpicks to be helpful as well). Make sure to clean the heatsink too, and apply some Arctic Silver (can be found at Radioshack). It's much better then the stuff they put on there.
But does it RROD right away, or after a few minutes?

[N64BitModder]

i did replace the stock compound and used Arctic Silver Ceramique. and i cleaned the heat sinks with Arcticclean. and also it RROD's instantly when the unit is turned on . hope that helps.

[bassmasta]

i did replace the stock compound and used Arctic Silver Ceramique. and i cleaned the heat sinks with Arcticclean. and also it RROD's instantly when the unit is turned on . hope that helps.

How many quadrants are flashing?

[N64BitModder]

3 lights are flashing in the quadrant, instantly when the unit is turned on with the error code 0203. i just redid the x-clamp fix-cleaned the heat sink and replaced the thermal compound, but still get the same problem.again hope that help

edit: should i just get a new jasper xbox 360? cause this is startin to be a waste of money, and i dont see no results out of this one.

[humakabula1]

if you do get a new one ill take that one off your hands

heres whats wrong..
you will get an instant rrod everytime. chip malfunction, not getting a connection to the board (not an overheating problem but a bad contact problem) mine turned out to be broken prongs in a corner on the gpu, missin 3 of them. didnt see this til i was comparing with another board. i believe these are mini resistors on the bottom side of the chip due to mistreatment

sad thing is there are NO fixes for it.