Drilling through 360 motherboard
Moderator: Moderators
-
notgoodenough4u
- Posts: 1
- Joined: Sat May 29, 2010 7:52 pm
Drilling through 360 motherboard
Is it going to f my board up if I drill through it to put different heatsinks in it?
-
jdmlight
- Posts: 795
- Joined: Thu Dec 27, 2007 11:17 pm
- Steam ID: jdmlight
- Location: A boring suburb of Chicago.
Re: Drilling through 360 motherboard
In all likelihood, yes. You should try to find a heatsink that is close to the right screw holes, then mod the heatsink instead of the motherboard.
--John (and please call me John, it's really weird to be called by my username)
Fight MS Paint abominations! If you don't have a camera, go here, and pick something 3 megapixels or higher.
Fight MS Paint abominations! If you don't have a camera, go here, and pick something 3 megapixels or higher.
Re: Drilling through 360 motherboard
It isn't a good idea, but depending on the size and location of the holes, you may be able to do it. Unless you're able to find a layout of the inner traces, there's no way to tell.
It takes a big man to cry, but it takes a bigger man to laugh at that man.
Ridonkulous
Ridonkulous