SNES RC battery & 3 way switch ?

KingzIE · Post by **KingzIE** » Sat Apr 30, 2005 6:38 pm

hello again everyone im, in the middle of trying to draw a diagram for connecting a 3 way switch for battery/dc input to my snesp project, now ive tried to compile info from all over the board on what connects to what but im totally stumped. Ive used the 3 way switch diagram on www.doomportables.com as reference but i dont no wether the pos and negative to snes connect to the pos/neg where the original dc jack used to be, on the LDO itself or on the switch connector that is inbetween the 7805/LDO and the DC jack? can somone give me a run thru on what wires need to be connected to the 3 points of the LDO if any for a 3way switch, what wires need to be connected to the DC jack pos/neg if any, and what needs to be connected to the switch connector (where the white jack used to be inbetween the DC pos/neg and the 7805/LDO
*this is on an SNES ver1 mobo*

KingzIE · Post by **KingzIE** » Sat Apr 30, 2005 11:10 pm

ahhh just rewired my battery included a recharge cercuit and all and it works great, the problem i had before was that i soldered leads going from the pos/neg from battery to my LDO which caused the system to draw constant power frm the battery even when switched to DC power, but now i realize i hook the pos and neg leads on my psone screen to the LDO/7805, correct?

also can somone give me a run thru on hacking my snes ver1 for rgb output on a sony psone screen?

thanks a lot!

nos_slived · Post by **nos_slived** » Sun May 01, 2005 12:49 am

It should already have RGB out. Read this.