My Results

G-force · Post by **G-force** » Thu Apr 28, 2005 9:06 am

I tried testing a PSX analog stick on an unnoficial N64 controller (made by performance). This is what happened when I tried using it on Goldeneye: Up and down would work but VERY slowly. Left and right wouldn't work at all.

Any idea why it didn't work? I suspect that the pots on the original controller was a different value than the PSX stick pots. Has anybody actually gotten this to work?

Alchemist · Post by **Alchemist** » Thu Apr 28, 2005 9:13 am

Whip out the multimeter and check the resistances.

nos_slived · Post by **nos_slived** » Thu Apr 28, 2005 6:07 pm

You will have to find a way to increase resistance in one direction, and decrease it in the opposite direction. This would probably require opening it and changing the clay/copper track. The only other way that I can think of is if you put a comparator on the line that could determine higher/lower resistance than what it is supposed to be. This could then control whether it goes through a higher or lower resistor. This would be hard though, because as a resistor gets hotter, it's value changes.

KJoshJ · Post by **KJoshJ** » Thu Apr 28, 2005 9:41 pm

would it be easier to use a gamecube analog stick? just wondering. Josh.

nos_slived · Post by **nos_slived** » Thu Apr 28, 2005 10:40 pm

It uses pots instead of an LED. I had posted instructions (omewhere around here) which should work, but I'm not sure.

*o* · Post by ***o*** » Fri Apr 29, 2005 1:35 am

i have looked and havent found anything

nos_slived · Post by **nos_slived** » Fri Apr 29, 2005 4:46 pm

http://www.benheck.com/ipw-web/bulletin ... php?t=2850