Is this right? 2.0

thewise1 · Post by **thewise1** » Mon Jan 19, 2009 3:12 pm

I can't quite tell where to wire everything in sifufs expansion pak relocation guide, the picture of it is too blurry, and I don't really understand circuit drawings either so I'm only guessing in this picture, and I want someone to confirm this before I wire it.

So here it is:

Is this correct?

NOTE: snoewboarders post is from another picture

Stoweboarder · Post by **Stoweboarder** » Mon Jan 19, 2009 7:20 pm

Yes, thats what i did

thewise1 · Post by **thewise1** » Mon Jan 19, 2009 11:00 pm

bump new question in first post!!

timmeh87 · Post by **timmeh87** » Tue Jan 20, 2009 7:09 pm

It looks pretty good man, TBH I dont know if many people will take the time to check each connection for you. People (me included) have posted scans of the n64 motherboard and the expansion pack PCB. The easiest thing to do would be to get those, and then do it yourself while checking them off in paint or something.

At least find them and link to them in this thread cause we are all lazy.

Make sure your pin 35/36 is right, thats really the only thing that got me.

eurddrue · Post by **eurddrue** » Tue Jan 20, 2009 7:21 pm

hey, buddy, you have made a lot of threads lately, maybe you should spend some time searching around the n64 forum so you don't have to keep making threads.

thewise1 · Post by **thewise1** » Tue Jan 20, 2009 7:33 pm

eurddrue wrote:hey, buddy, you have made a lot of threads lately, maybe you should spend some time searching around the n64 forum so you don't have to keep making threads.

I know, and I've been meaning to do that. But since I've been talking so much I just modified this thread instead.

thewise1 · Post by **thewise1** » Fri Jan 23, 2009 7:48 am

timmeh87 wrote:It looks pretty good man, TBH I dont know if many people will take the time to check each connection for you. People (me included) have posted scans of the n64 motherboard and the expansion pack PCB. The easiest thing to do would be to get those, and then do it yourself while checking them off in paint or something.

At least find them and link to them in this thread cause we are all lazy.

Make sure your pin 35/36 is right, thats really the only thing that got me.

You don't have to check everyone, you just have to compare it to the job you guys have done. You had to know where everything goes too. You don't have to go opening up your portables for me.