Does intec gc screen have rgb in?

Maniac_Man · Post by **Maniac_Man** » Tue Mar 29, 2005 8:48 pm

I have the intec gc screen and theres just the lcd board and then the header board. When the thing was not taken apart, it only had composite in. is there any way to have it rgb in?

Edit: I searched for the gc screen thing but it was never confirmed taht rgb worked in it, or where to put it. Also, is there any way i could decrease the redness on it?

segasonicfan · Post by **segasonicfan** » Sat Apr 02, 2005 1:08 am

adding RGB to devices that have a designed composite in is surprisingly hard. The composite signal goes to a chroma encoder where it is then split to the RGB signals for the LCD. You can search around for a small square chip with 40-60 pins (probably the smallest most complex chip you can find in there) and that will be the chroma encoder. If you're really determined you can search for a data sheet and figure out how to undo the comp in and switch to an RGB in but just trust me it's more trouble than it's worth and you'll break your chroma encoder at best.

-Segasonicfan

segasonicfan · Post by **segasonicfan** » Mon Apr 04, 2005 3:47 am

UPDATE: I just opened mine and went through hell to find the RGB. I found it though-not on the boards but on the Sharp screen (that's what it really is) inputs. I can give you the pinout if you really want I tested it and it works. Unfortuntely there is some crossover with the standing image but I belive a couple capacitors can be used to solve this problem. I'll continue to update this post with my results.

-Segasonicfan

Maniac_Man · Post by **Maniac_Man** » Mon Apr 04, 2005 4:37 pm

cool, sorry i didnt reply. i had some troubles at home. but when you see if it actually works tell me what stuff i need to get and the if you gave me the pinouts that would be awsome.

Post by **bicostp** » Fri Apr 08, 2005 7:27 pm

Sorry. I posted a link to a replacement GBA screen (That's what I thought you wanted.) I should read more carefully.

I'm sorry you're having trouble at home, man.

Niku-Sama · Post by **Niku-Sama** » Sat Apr 09, 2005 10:10 pm

are you considering the 5 inchers that show up for super cheap for game cube too?

i figure its gotta use RCA, Composite or SOMEthing standard to use

*o* · Post by ***o*** » Mon Apr 11, 2005 5:45 am

can you please tell me about the screen

What voltage does it need? if i use this wiring:http://www.doomportables.org/images/n64wiring.gif it says it for the interact.

*o* · Post by ***o*** » Mon Apr 11, 2005 2:57 pm

I have the intec screen and if i use the wiring diagram from my previous post will it work