Question about the Xbox Hip Screenpad

TheOnlyOneHeFears · Post by **TheOnlyOneHeFears** » Sun Dec 31, 2006 11:09 am

Is the circuit board inside the Xbox version of the Hip Screenpad the same as the PS2 version? Would ladyada's pinouts and segasonicfan's picture apply to the Xbox version? If so, then I am SORTED for a screen :p Once I get it, I'll tell you UK people where to get it from

Pic:

I think it's the controller G-Force used for his LED skull mod (which was so sweet :p)

EDIT: Packaging picture

I'm pretty sure it's the same

Post by **CronoTriggerfan** » Sun Dec 31, 2006 12:18 pm

Yes, the motherboards in all models of the HipGear (PS2, GC, and Xbox) are all the same.

CTFan

figmentfilm · Post by **figmentfilm** » Sun Jan 21, 2007 8:35 pm

I've had a few minor differences between a few I've toyed with. On some, the backlight is soldered to the board, and on others it has a connector. also, I couldn't get the monitor from one (ribbon cable, rather) to fit into a second board... other than that, easy stuff.