leap frog

Mr.Game and watch · Post by **Mr.Game and watch** » Fri Oct 27, 2006 9:54 pm

can you use a leap frog sceen lcd and iam a new person here

atari2600a · Post by **atari2600a** » Fri Oct 27, 2006 10:12 pm

See if the screen gets it's input from the same trace that supplies the composite signal it outputs to televisions. There you will get your awnser.

Mr.Game and watch · Post by **Mr.Game and watch** » Sat Oct 28, 2006 10:16 am

its gots good lcd those i just need to buy atari flashback 1 and lesp frog for the sound and LCD

demonofaj · Post by **demonofaj** » Sat Oct 28, 2006 10:28 am

Leap Frog?

. Atari, that's straight of the bat no. There are no analog input points on these kind of LCD's AT ALL. Nevertheless, my little brother has one of these and the quality SUCKS. Those analog points you say were all output for a larger TV screen.

In short: NO!

atari2600a · Post by **atari2600a** » Sat Oct 28, 2006 3:04 pm

Have you even looked? It sounds logical that Leapfrog would just use an off the shelf analog-input LCD than to have some company build some w/ digital-input PCB's specifically designed for the system itself. (But w/ Nintendo it's different, as they manufacture their systems on a much larger scale)

EDIT: The screen outputs composite, just for the record...

tom61 · Post by **tom61** » Sat Oct 28, 2006 10:15 pm

Err, digital interface to LCDs is fairly standard and cheap, so no need to have the extra circuitry to decode NTSC in embedded devices.

Not imposible for a screen inside a device to be composite, but it is the exception, not the rule.