How to make 72 pin connector with floppy cables

chanticlair281 · Post by **chanticlair281** » Sat Aug 12, 2006 7:24 pm

I am wanting to find(or Make) a how to on making the 72 pin connector using the two floppy cables that Ben uses. Anyone have any suggestions on where to start?

Klefmung · Post by **Klefmung** » Sat Aug 12, 2006 7:28 pm

Get some, chop 'em up. It is obvious. I figured it out. <_<

chanticlair281 · Post by **chanticlair281** » Sat Aug 12, 2006 9:06 pm

I was hoping to create a step by step, cut this piece, soder this wire there type pictured tuttorial.

Klefmung · Post by **Klefmung** » Sun Aug 13, 2006 11:00 am

Well, you will have to cut one side of it to where the opening is available. Do that on the other one. there is like, a wall in the middle of some of the connectors. heat up a knife on fire, slice through it. bam. now, since it is the connector at the end of a cable, it is already connected to wires. Solder those wires to the board. Bam. Connector