AAAAAAHHHHH!!!!

Darth Fett · Post by **Darth Fett** » Thu Mar 16, 2006 5:42 pm

*Censored word*!I was fixing my poor little Gamecube,and the Pot BROKE!!!!It snapped off!What can be done?!Can it be saved?!Only.....if you guys know what to do.

Metroid fan · Post by **Metroid fan** » Thu Mar 16, 2006 6:56 pm

Yeah I think so just use a regular resistor thats the same amount as the old pot I think......

demonofaj · Post by **demonofaj** » Thu Mar 16, 2006 7:31 pm

Or you can rewire it

Darth Fett · Post by **Darth Fett** » Thu Mar 16, 2006 8:46 pm

demonofaj wrote:Or you can rewire it

You misunderstand.It snapped in half.The bottom part is still on the Gamecube.

Post by **Skyone** » Fri Mar 17, 2006 1:50 am

Scotch tape, perhaps?

demonofaj · Post by **demonofaj** » Fri Mar 17, 2006 4:34 pm

Actually, if just the PRONGS broke, you're ok, but if the whole pot broke you're screwed and in a medical mishap

scherzo · Post by **scherzo** » Fri Mar 17, 2006 4:39 pm

Can't it just be desoldered and replaced?

Darth Fett · Post by **Darth Fett** » Fri Mar 17, 2006 5:51 pm

I just tried to turn it on.The fan starts spinning,but the disc doesn't move.

Zzebotes13 · Post by **Zzebotes13** » Fri Mar 17, 2006 9:22 pm

if it's out of the case, make sure that the disk drive isn't plugged into the gamecube motherboard completely. the same thing happened to me. If it is plugged in too much, it won't work

usbcd36 · Post by **usbcd36** » Sat Mar 18, 2006 7:49 pm

Which pot are you talking about?