getting really close to actually doing something!

jeffslot · Post by **jeffslot** » Sun Oct 16, 2005 6:00 am

bicostp,

So unless I'm confused again (quite possible) then I believe my 1st & next step will be to attatch the battery wires (red & black) to the corresponding wires onthe pin out (red & black).

I tried to show in the picture below what I have in mind, does that look right?

Thanks again.

http://img436.imageshack.us/img436/1355 ... ady9pk.jpg

madc0w · Post by **madc0w** » Sun Oct 16, 2005 7:48 am

why is this in the trading post?

Post by **Black Six** » Sun Oct 16, 2005 8:56 am

The pic you linked to looks a bit like on of those Atari Flashbak units, so I'm gonna move this over there, hope that's right...

Post by **bicostp** » Sun Oct 16, 2005 9:17 am

Looks like one of the 10-in-1 Direct-to-TV Fake Atari joysticks.

No, the red wire is for the right audio signal. I sent you the pinout for the Intec screen, either the orange or brown wire is the power.

So basically you're about to put several volts of power into the audio amp circuitry. Bad idea.

atkafighter · Post by **atkafighter** » Sun Oct 16, 2005 12:14 pm

I remember the hipgear/intec wires by heart (pathetic I know).
Orange - +V (enough for the 7805)
Green - GND
Black - GND
White - Audio
Red - Audio
Yellow - Video
Brown - Video GND

shmagoogin77 · Post by **shmagoogin77** » Tue Oct 18, 2005 8:21 am

exept the intec screen has no green wire