adjustable regulator question

Want to just shoot the breeze? Forum 42 is the place!

Moderator: Moderators

Foxx373
Posts: 542
Joined: Thu May 12, 2005 11:45 am
Location: Brooklyn, NY

Post by Foxx373 »

your dad is wrond. When you hook up the resistors to the LM317 regulator, it will output the desired voltage. It does not have to be hooked up to your device to output the voltage level you want. You pumped in 7.5V acrosss a 3.3V line. Your N64 is nuked.
SpongeBuell
Senior Member
Posts: 5190
Joined: Wed Apr 07, 2004 10:52 am
Location: Colorado
Contact:

Post by SpongeBuell »

yeah, volts are forced through, no matter what the load needs. You cannot lower or raise the voltage by plugging it in (with the exception of regulators and resistors inside) Current, however, can fluctuate based on the needs of the system.
Life of Brian wrote:
RYW wrote:RYW:

Rare
Yellow
Weasel
I'll be honest with you - I would have never guessed that.
Xorealix
Posts: 71
Joined: Thu Aug 11, 2005 5:28 pm

Post by Xorealix »

Foxx373 wrote:Your N64 is nuked.
Just tested it today after resoldering the power connector. Still works. Even after dropping it on cement with everything exposed. (Four feet, haha)


I don't know how you people destroy these things.
Foxx373
Posts: 542
Joined: Thu May 12, 2005 11:45 am
Location: Brooklyn, NY

Post by Foxx373 »

you put 7.5V across a 3.3V line and it still works?! Damn, i agree, how the hell do people keep frying their N64s! I did such a butcher job to my Jumper/Expansion pak connector. Tthe Expantion pak is dead though, I need to buy a new one, or build a jumper pak, and that wasnt my fault, the pak was dead before I f-ed with it.
Xorealix
Posts: 71
Joined: Thu Aug 11, 2005 5:28 pm

Post by Xorealix »

Foxx373 wrote:You can use a 1.3K and 2K resistor to get 3.27V.
Oh my gosh.

A week ago I went to the shack and bought 2.2k and 1k resistors, thinking those were the ones you mentioned above. I did not think to double check the numbers before purchasing them.

Had a friend come over, and we wired up the LM317 with those (wrong) resistors. Checked the voltage output- it was around 4.4V. Crap, I thought.

We unsoldered our wires for the AV port today, and stuck the connector back in. Next we hooked up the 64 to the TV using our regulator and 10 AA's wired in two parallel sets of 5.

Not only did it NOT fry itself, but it TURNED ON.

AND IT WAS PLAYABLE!

Unbelievable. N64 running on 7.5V going to the 12V in, and 4.4V going to the 3.3V in.
Post Reply