HOW THE %$^@&(@!$ ARE YOU SUPPOSE TO OPEN A MINI SNES

MR-sp · Post by **MR-sp** » Sun Aug 01, 2004 2:27 pm

Anybody know how to open A DAG-BLASTED Mini SNES without breaking the case also do any of you know where to get A nintendo screwdriver
I have cheked ebay and there SOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO
$$$$$$$$$$$$$$$$$$$$$$$EXPENSIVE$$$$$$$$$$$$$$$$$$$$$$$$$$$$$

Post by **gannon** » Sun Aug 01, 2004 2:31 pm

As posted in another thread, the screw driver for it is expensive, when I open my store I hope to sell these for $7.50. You can find the bit sets on ebay for around $15.00-$20.00.

electromaster64 · Post by **electromaster64** » Fri Aug 06, 2004 10:56 am

look on www.doomportables.org at my SNES how too.

yalborap · Post by **yalborap** » Tue Aug 10, 2004 4:28 pm

Dremel is your friend. Just hack off as much as you can so you can get to the screws, and drill them to oblivion.

or go with my way and contact cement a screen onto the backend of it, and wire a couple of batteries to it all withoiut cracking the little bugger open.

Kefka · Post by **Kefka** » Wed Oct 27, 2004 7:35 pm

http://mcm.newark.com/NewarkWebCommerce ... 2-1150&N=4

Doubt you'll ever see this though...

Kefka · Post by **Kefka** » Wed Oct 27, 2004 7:37 pm

and if you happen to want to open carts as well...

http://mcm.newark.com/NewarkWebCommerce ... 2-1145&N=4

Dave · Post by **Dave** » Wed Oct 27, 2004 9:47 pm

Yeah I got my bits from MCM

JackFrost22 · Post by **JackFrost22** » Thu Oct 28, 2004 2:23 pm

Ball point pen. It really works, trust me.