placement of buttons

[jeffslot]

Hello,

I think I'm going to abandon my engraving plastic case for my 2600 project. I've already bought an inexpensive tacke box to use as a replacement. I did this because I was having trouble getting everything into the other case.

This brings me to my question. Does anyone have any tips on how to get the buttons to sit well in a case. I guess I can always use the method that ben uses in his book with the nylon spacers. I was just wondering if there were any other ways. thansk.

Jeff S

[*o*]

get blank pcb and hot glue them down. you can the run the wires through holes in the board!

[EvilnessNMyVeins]

If it came with removable spacers use them to raise the PCB board