Pins fell out of motherboard

[Arc64]

While removing the ports from my motherboard, some of the pins fell out, leaving only the holes. I figure I should still be able to solder the holes, but I want to make sure this is okay. Can I still resolder the points if the pins fell out? If not, can I fix this?

[FLAPJACKDAN]

Are you talking about the extension port on the bottom of the n64? If so you don't need to fill them up.

[Arc64]

Controller and power ports.

[FLAPJACKDAN]

Well if you plan on bridging the power switch and using the player ports then yes you solder the holes.