N64 LED mod questions

[SackAttack]

I'm wanting to put two led's in my N64. I'm going to switch out the standard red one (easy) and add another led at the air vents by the cartridge slot; but I don't know where to tie in the led to the circuit board. If any one has a diagram or a picture of where to solder in at that would be awesome. Also, will I need a resistor?

[Hrduncan]

you dont need resistors just open up the n64 and follow the 3v line to the switch once youve found the switch solder a wire to it and then wire each led to ground and 3vs

[gamax92]

Wouldn't Add LED's on that line Put Pressure On The Board.

Some Stuff May Get Under Powered.

I'd Would Recommend Using A Volt Meter On The Line Afterwards

[nevermind1534]

LEDs barely use any power; you could probable hook up more than you can fit into the N64 before you start seeing any problems. I'm able to light up the blue LEDs that I use by holding one end to the ground or a grounded surface, while holding the other end.

[gamax92]

LEDs barely use any power; you could probable hook up more than you can fit into the N64 before you start seeing any problems. I'm able to light up the blue LEDs that I use by holding one end to the ground or a grounded surface, while holding the other end.

I Just Relized That LED's really use no power. I think A Blue LED Is Cooler Than A Red One.

[Hrduncan]

[SackAttack]

(Hrduncan)
Nice job on the 64, it looks real good. I'm going to put LED's on the side vents now like you did. How many LED's do have in the 64?

[Hrduncan]

I think around 20 or less. works great still!