FC16 Go switch 50Hz/60Hz but Black And White

[Risike]

Hi everybody !

Sorry for my bad english.

I have modded my FC16 Go. V2. I have added a switch to switch between 50Hz and 60Hz. So every PAL and NTSC (US and JAP) games works except Mario RPG...Etc.
But in 50Hz mode, the screen is Black and White. How can I have colored games.

(For the moment, I launch games in 50Hz, then I switch them in 60Hz when the protection is read)

[hailrazer]

The screen is most likely not 50hz compatible. Of course that sounds quite obvious now that I said it.

[Risike]

I'm not sure. If you put a 50/60Hz switch on an american Super Nes, you will have the same problem. So I don't think it's the screen.

[hailrazer]

I'm not sure. If you put a 50/60Hz switch on an american Super Nes, you will have the same problem. So I don't think it's the screen.

Yes you will have the same problem with the T.V. not accepting the 50hz signal so it shows up in black and white. Same exact problem here. The screen can't handle the 50hz signal so you get a bad picture.