-N64 installed
-controller board installed
-batteries installed
The N64 does not require RCP wiring to fit in, just a little bit of trimming. The controls are alreayd mounted, they just need the board wired to them. And of course the battery is a very simple install.
Specs:
7.4v 4400 mAh Li Ion battery with charger that can let the system play while charging
3.5" screen, very high quality, LED backlight
Bondo/epoxy putty controls
AG-85 (Damn small.)
I will help the buyer through finishing it, if they have any questions about the design of the portable, how it's all meant to fit together in the end, etc. I will have an N64 that I can ship along with it in about a week if the buyer wants one.
This includes:
Case, complete, painted, clearcoat. 6 coats each primer, paint, and clearcoat for maximum scratch protection.
3.5" screen installed
Control board installed
Extra controls + power switch + power plug installed but not wired
Cart slot with IDE cable soldered, ready to go on n64.
4400 mAh lithium ion battery pack with charger
Wheel pot for audio amp
Audio amp installed
Speakers installed
Extra information about batteries, pinouts for them.
N64 controller board
Cut down N64 jumper pak (I can include an expansion pak if you give me a little more.)
Heatsink
The case is a bit dirty right now, that's why it's all smudged up etc.
Make an offer.
I will consider all offers, do not hesitate. I need to sell this quickly!
This being an unfinished mod no returns will be accepted, sorry.
