Carmany's Progress

[Carmany]

After asking some questions I will begin creating my portable. This is for a school project. So far I have disassembled the PS1 Screen.


Now taking a look at the bottom left of the screen I have separated the power wires from the rest. Can I just cut the extra wires from the board and leave them? Or do I need to do something else with them even though I will not use them.
I can also disconnect the wires from the screen, and by doing that it leaves me with the prongs, should I just solder my 2 wires to the 2 needed prongs and leave the rest alone? If you need more pictures of elaboration let me know. Thank you.

[Carmany]

That actually helps a lot, but what I want to do is attach wires this way:

Is there any problems with the attachment still being there? or do I need to remove it?

[Carmany]

Thank you I was going crazy, I will leave the clip there, but solder the wires behind it.

[MarioOwnsAll]

That actually helps a lot, but what I want to do is attach wires this way:

Is there any problems with the attachment still being there? or do I need to remove it?

You can use the attachment but it's not recommended because there are solder pads on the back of the board which work just aswell and that way you can remove the two plugs at the bottom and save room inside the portable.