I was attempting the psone hack...so got the picture using my svideo and powering with my ps2 powersupply...that worked...then i went to do the lm317 circuit so i can power it thru my PC power supply...however, i screwed up on the wiring...befiore i knew this i just plugged in cos i thoguht i did it correct..and screen didnt turn on...so i grab the meter and test the voltage at the connection point at the psone lcd...read like 3.06v....
then i looked at my circuit again on the lm317...i soldered the output wire to the ADJ pin...then i re did it..and it was correct...i tested it with meter and it read 7.56v...so plug it in...and my screen turns on...but...the picture i get was so dark i can barely see it...had to tilt it...and there was no color....so screen was just black with a small shade of white for the picture im displaying...back light is fun... but when i press the volume/brightness controls, i see the green adjusting bar fine....
is my PCB fried or sumthing?
my PSone screen dead?
Moderator: Moderators
-
limpport
- Senior Member
- Posts: 1873
- Joined: Sun Jan 29, 2006 12:32 pm
- Location: (the only person here from) Vermont
- Contact:
Re: my PSone screen dead?
Check your inputs soldered to the screen mobo and resolder them.