zn-45 portable help

[z2442/joey]

hello guys i have this problem i have no idea how they managed to fit the n64 controller board in there i just can seem to make it sit near the surface by the screen its just too big can any one who has a idea on how or who has made a n64 into a zn-45. i made one before it is my picture i had no room before because i used a 7 inch but now im using a 3.5.....help plz

[MarioOwnsAll]

hello guys i have this problem i have no idea how they managed to fit the n64 controller board in there i just can seem to make it sit near the surface by the screen its just too big can any one who has a idea on how or who has made a n64 into a zn-45. i made one before it is my picture i had no room before because i used a 7 inch but now im using a 3.5.....help plz

The original buttons are smaller but harder to work with because they are made for the actual controller, anyway just follow the traces on the controller board and you should find little solder pads for the buttons I would recommend using radioshack buttons because they are much more sturdy on the end of the button there should be two little metal prongs. Just solder the "A" button to one of the metal prongs and solder the other prong to ground and theres your button (do the same for all the other buttons).