Is this safe? Would it work?

limpport · Post by **limpport** » Mon Jan 18, 2010 4:29 pm

Would I be able to use the battery charge jack as wall power where it is instead of the PSone charger?

limpport · Post by **limpport** » Tue Jan 19, 2010 7:01 pm

Anyone at all?

Say the PSone plug was not there. Could I have the battery charger charge the batteries and run the N64 at the same time?

collinE · Post by **collinE** » Tue Jan 19, 2010 8:18 pm

yes you may, good sir. as long as it's a 7.4v charger.

limpport · Post by **limpport** » Tue Jan 19, 2010 10:29 pm

Awesome! The charger is 8.4v, so that should still be safe for the PSone screen.

Kyo · Post by **Kyo** » Wed Jan 20, 2010 1:06 pm

I would recommend against using that.

thewise1 · Post by **thewise1** » Wed Jan 20, 2010 3:58 pm

Well 7.4v chargers do measure at 8.4 volts. Did you measure that or is that what the charger is rated on the brick for?

limpport · Post by **limpport** » Wed Jan 20, 2010 11:42 pm

It says the output is 8.4v.

Kyo wrote:I would recommend against using that.

I put the PS1 jack into my portable for wall power anyways

thewise1 · Post by **thewise1** » Thu Jan 21, 2010 12:28 am

That will work fine for charging and if it's enough amperage it's fine for powering.

Kyo · Post by **Kyo** » Thu Jan 21, 2010 3:25 am

The thing is just that 8.4V is very close to the frying point of the psone screen. You better be sure it stays stable.

thewise1 · Post by **thewise1** » Thu Jan 21, 2010 7:46 am

I use that charger all the time for my starlight 64.

limpport · Post by **limpport** » Thu Jan 21, 2010 8:44 pm

It the standard charger for 7.2v Li-ion batteries from batteryspace, so I hope it'd stay stable!

benheck.com Forums