12v Wall adaptor?

[Klaymator14]

Now, I don't have my batteries yet, but my picoPSU arrived in the mail today. So I need to power it using a 12v wall adaptor. Does it need to supply a certain amount of mA? Or should I be fine? Thanks in advance!

-Blayke

[Klaymator14]

Oh, I also have another question, a long time ago, I cut off the wires for the fan, but I do not remember which wires went to which... anyone know?

[snowpenguin]

You cut the fan wire, or cut it from the circuit board? You ought to be able to amtch up colors, or maybe there's labels on the circuit board.

[Klaymator14]

Nevermind, I got the fan working, as well as the Dreamcast running on the PSU, and I just checked... my screen has just came in! Now I can just wire that up as well, now all I need delivered is my battery, and my Quantum controller, then I will make the case! Thanks everyone!

[Klaymator14]

I have another question... Well, I had the picoPSU hooked up and everything earlier, but I didn't solder the wires into the PSU, I just stuck them in there. So now that it was working and the red light turned on, I decided to solder them, so I did. I did it directly to the pins under the plastic molding. But now, the red light doesn't turn on, only the green light. I was pretty sure it had to do with linking the PWR_ON and GND together, so I desoldered it, and just stuck it in the pins like before, but it still doesn't work.... anyone have any ideas? I don't know how I could possibly break something on the first day...

-Blayke