Micro fan installation question(n64)
Moderator: Moderators
-
monkeymetroid
- Posts: 38
- Joined: Sun Aug 30, 2009 8:28 am
Micro fan installation question(n64)
Where on the n64 would you solder for a micro fan?
-
Kurt_
- Portablizer
- Posts: 5748
- Joined: Thu Nov 24, 2005 10:32 am
- Steam ID: kurbert
- Location: Ontario, Canada
- Contact:
Re: Micro fan installation question(n64)
Check the power requirements. If it's 5 volts and doesn't draw too much current, which is probably the case, you can solder the black wire to ground and the power wire (red, probably) to any +5V source, preferably directly after a regulator.
Hey, sup?
-
monkeymetroid
- Posts: 38
- Joined: Sun Aug 30, 2009 8:28 am
Re: Micro fan installation question(n64)
oh alright, thats sorta what I was thinking but I wanted to make sure first. thanksKurt_ wrote:Check the power requirements. If it's 5 volts and doesn't draw too much current, which is probably the case, you can solder the black wire to ground and the power wire (red, probably) to any +5V source, preferably directly after a regulator.
