QUESTION is there any ware else to input voltage plz HELP!!

[z2442/joey]

it all seems to be ok but when i was removing the power connecter thing i sorta broke off a little tiny pice of the mother board right below it ware i had all of my wires for the n64 is there any ware else on the board i can put theses inputs for positive 12v ground and 3.3v ???

[XCVG]

Look on the bottom of the board. If you still can't figure it out, well, um, I actually don't know.

[z2442/joey]

i am but i relly do not want to fry it

[robm]

Right at the power switch will be fine. Just be absolutely sure you have everything connected right, and remove the switch. Saves space that way anyway.

[ShockSlayer]

Connect 3.3v to pin 6 and 7.2v to pin 7 underneath the power switch. Also, connect GND to one of the four posts that hold the power switch on.

SS

[z2442/joey]

well thanx guy i relly needed the help

[z2442/joey]

sry to double post and yea i fixed it

[ShockSlayer]

Good, hope it goes ell for ya.

SS

[z2442/joey]

k every thing is done but the controls and putting it the case so it wont be but a maybe a few days b4 im done my second portable lol