Help please with my snesp video!!

meanyoshi · Post by **meanyoshi** » Sat Jan 17, 2009 11:02 am

hello i really need this help. i am so close in finishing i can almost see it! well almost... i can get the LED'S to light up and i can get the sound but no video!!!! i have composite video hooked up from the snes board to pin 1 on the ps1 screen but still no video....any suggestions?

themadhacker · Post by **themadhacker** » Sat Jan 17, 2009 11:05 am

perhaps you got positive and ground confused on the video part. Maybe you should check your connections.

darthchris13 · Post by **darthchris13** » Sat Jan 17, 2009 4:42 pm

If you have sound, it is not a problem of power supply,are you sure your wire is connected on pin 9 of the snes board ?

meanyoshi · Post by **meanyoshi** » Sat Jan 17, 2009 7:17 pm

i have tried pin 9 for composite video, and i have also tried regular video....is there a way to tell if your screens fried? i think it might be.....i need a way to check if it is so if theres any suggestions please tell me.

meanyoshi · Post by **meanyoshi** » Sat Jan 17, 2009 7:18 pm

and i know its wired right, so i know ground and postive is not mixed up...i can get the LED's to light up, but no video...

darthchris13 · Post by **darthchris13** » Sun Jan 18, 2009 9:03 am

If you think all is wired right but doesn't works you can bypass the fuse of the screen to see if it is fried or not.

Can you take a picture of your system?In detail if it's possible.

meanyoshi · Post by **meanyoshi** » Sun Jan 18, 2009 10:29 am

yeah ill try to get pictures up ASAP! but can you tell me what the easiest way is to bypass the fuse? sorry for all these questions.

themadhacker · Post by **themadhacker** » Sun Jan 18, 2009 10:54 am

meanyoshi wrote:yeah ill try to get pictures up ASAP! but can you tell me what the easiest way is to bypass the fuse? sorry for all these questions.

blop solder where the fuse was.

meanyoshi · Post by **meanyoshi** » Sun Jan 18, 2009 1:52 pm

my dad said that if you take your meter and try to check resistance and put 1 lead on each side of the fuse and you get a reading your fuse is not blown. i tried that and it said the fuse wasnt blown so now i am in mystery. i will look over my wiring again.

Kurt_ · Post by **Kurt_** » Sun Jan 18, 2009 2:34 pm

$10 says the video wire's on the wrong pin/bridged.