nes problem....is it just the 72 pin connecter?

Includes Atari 2600, Nintendo 8-bit, Sega Master System, MSX and more!

Moderator: Moderators

Post Reply
yoshilime
Posts: 491
Joined: Thu Sep 18, 2008 11:47 pm

nes problem....is it just the 72 pin connecter?

Post by yoshilime »

my nes stays on for 10 minutes, then shuts off. is this just the 72 pin connector, and i need to replace it? help soon.


-yl
Sometimes, life isn't fair, but you just have to work around it.

Excellent
Ben Cebhrem
Posts: 302
Joined: Thu Jul 05, 2007 12:00 am

Post by Ben Cebhrem »

The only way it could be the connector, is if it is losing connection with the lockout circuitry. This would result in a flashing NES at that point however.

Can you check the regulator? I'd suspect that as the culprit first. Either overheating due to never being cleaned out, or just gone south for the winter.
yoshilime
Posts: 491
Joined: Thu Sep 18, 2008 11:47 pm

Post by yoshilime »

and i'd just replace those if that was the case? is that hard?
Sometimes, life isn't fair, but you just have to work around it.

Excellent
Ben Cebhrem
Posts: 302
Joined: Thu Jul 05, 2007 12:00 am

Post by Ben Cebhrem »

Not hard at all to replace the regulator. It's a standard 7805 regulator; three pins to desolder, one screw to remove; reverse the process to add one in.
themadhacker
Senior Member
Posts: 2670
Joined: Wed Aug 06, 2008 7:53 pm
Location: ohio

Post by themadhacker »

I had the same problem with my genny 2. Never knew it was the regulator.
rest in peace, Ronnie James Dio! \m/
17daysolderthannes
Posts: 381
Joined: Thu Oct 18, 2007 7:15 am

Post by 17daysolderthannes »

Ben Cebhrem wrote:The only way it could be the connector, is if it is losing connection with the lockout circuitry. This would result in a flashing NES at that point however.
it could also result in garbled graphics, there are a bunch of problems that can be caused by the connector, but I wouldn't imagine shutting off is one of them. It could also be a slightly damaged power plug/almost broken solder joint on the power plug. I fixed an XBOX once that had broken the joints holding the power plug to the board.
yoshilime
Posts: 491
Joined: Thu Sep 18, 2008 11:47 pm

Post by yoshilime »

are there guides or how-tos on any of this?
Sometimes, life isn't fair, but you just have to work around it.

Excellent
themadhacker
Senior Member
Posts: 2670
Joined: Wed Aug 06, 2008 7:53 pm
Location: ohio

Post by themadhacker »

giude on bad solder joints or a bad regulator?
rest in peace, Ronnie James Dio! \m/
Kyo
Senior Member
Posts: 2470
Joined: Tue Jan 02, 2007 11:59 am
Location: Germany

Post by Kyo »

if the lockout isn't getting what it wants, it would blink, not shut off
Post Reply