WTB: Noac

SonyPortableizer · Post by **SonyPortableizer** » Thu Oct 16, 2008 6:11 pm

I have a SJ3
But...I destroyed the leads between the controller part and the cartslot part, and a cartslot screw hole that sticks off the side is broken

Valium · Post by **Valium** » Thu Oct 16, 2008 6:20 pm

Snowkitty- let me know, I'll be needing a few of these over the next while

Neildo- As long as it's got good games and works, I want it.

Sony- What built in games, and what exactly is wrong..? Does the controller not work anymore, or is that just the 2nd player? Cart slot doesn't matter unless it's NTSC, if it's PAL I'm just dumping it anyway.

SonyPortableizer · Post by **SonyPortableizer** » Thu Oct 16, 2008 6:23 pm

NTSC
And well I tried to rewire that grey cable, but since I still dont own anything to desolder with, I tried pliers...
Before that everything worked
It has the 76 built games in like a SJ3, LOB used it, GamerGRRL used
All those games

And would you mind If I left the crappy re-soldering job on if I send it?

Valium · Post by **Valium** » Thu Oct 16, 2008 7:10 pm

Can you show me a pic? I still don't understand completely what you did.

SonyPortableizer · Post by **SonyPortableizer** » Thu Oct 16, 2008 7:15 pm

Ill just say what I did, no camera currently
There are (I think)10 wires that connect the controller the the cart slot
I tried to extend those wires, but I couldnt desolder, so I yanked on the cord until it came out
Then the small traces in the PCB were yanked out-about 2/3 of them

Valium · Post by **Valium** » Thu Oct 16, 2008 7:22 pm

Oh, so the cart slot isn't soldered directly to the board, I getcha.. That's bad news, I don't have room for any extra wires in this project.

SonyPortableizer · Post by **SonyPortableizer** » Thu Oct 16, 2008 7:24 pm

Not the cart slot, thats still intact this

The grey cable in the lower left corner
THats what I failed at

Valium · Post by **Valium** » Thu Oct 16, 2008 7:29 pm

So all that is is the controller? I don't need it anyway to be honest. Can you measure the board for me?

SonyPortableizer · Post by **SonyPortableizer** » Thu Oct 16, 2008 7:43 pm

Connectings to controller yes, so not problem
Width of a NES cart
2 inches tall

Valium · Post by **Valium** » Thu Oct 16, 2008 7:56 pm

The board, not the cart slot.

SonyPortableizer · Post by **SonyPortableizer** » Thu Oct 16, 2008 7:57 pm

No the board is as wide as the cart slot
And 2 inches in length

Valium · Post by **Valium** » Thu Oct 16, 2008 8:03 pm

Okay, sounds good. It works right? Shoot me a pm with your asking price, it isn't perfect condition after all