WTB: Super tiny soldering iron tip.

Dr. KillGood · Post by **Dr. KillGood** » Thu Aug 21, 2008 3:06 am

I mean SMALL, like the tip of a pin small. Not a pen that you write with, but a pen that you stick into your clothes!

SMALL!

Post by **Skyone** » Thu Aug 21, 2008 3:18 am

You really think anyone here know what size/type of tip you're talking about?

Dr. KillGood · Post by **Dr. KillGood** » Thu Aug 21, 2008 3:35 am

Is their a size chart somewhere?

Post by **Skyone** » Thu Aug 21, 2008 3:38 am

No, what iron are you using?

Dr. KillGood · Post by **Dr. KillGood** » Thu Aug 21, 2008 3:49 am

Radio shack one. =P

Valium · Post by **Valium** » Thu Aug 21, 2008 7:05 am

Pretty sure they don't make them that small due to heat limitations.

palmertech · Post by **palmertech** » Thu Aug 21, 2008 10:28 am

I wonder if you could make a screw tightened one using sewing needles... That would be interesting. Even if the tips burn out in an hour, no problem. You can get a little box of 50 for like $2.

I might have to try that...

dragonball345 · Post by **dragonball345** » Sat Aug 23, 2008 3:26 pm

make a custom head where you could install them would be very easy just cut off the top of the screw and if it will thread in your golden should try that 2 be cheap.

Post by **Triton** » Sat Aug 23, 2008 7:17 pm

weller WM120 is about as small as you can get. .4mm tip size (tip is a little smaller than mechanical pencil lead) they cost about 35$ shipped