N64 Portable, but with normal N64 controllers?

Gordon1 · Post by **Gordon1** » Wed Jul 23, 2008 11:59 am

bacteria wrote:
ShockSlayer wrote: An inverter to get your voltage down to 3v or 3.3v , nothing else is acceptable, even though bacteria says 3.89v! He's a liar!
You are a bit cocky, mate!

I quoted 2.89v as being the minimum voltage on the 3.3v line that the N64 works at (I ran my Nintendo 64 Advance on 2.89v). Now I use a TI card rather than a car adaptor, I tend to have this voltage between 3.2v and 3.4v.

ShockSlayer wrote: But dont take my advice. I've built six portable n64s, 3 portable wii's, 1 portable gamecube, 1 portable snes, and various handheld(ds, psp) mods. Its not like I would know anything at all about this stuff.
...of various quality and lugability.

Nice one Bacteria!

Post by **Skyone** » Wed Jul 23, 2008 12:22 pm

I doubt the intentions of the original topic starter were to create a battle of wits (or lack thereof). Anyway, the point of this topic is too vague and blurry to answer to. Please research around this forum, and if questions persist, please be specific.