Pal snes s-video

jeroen · Post by **jeroen** » Mon Jul 14, 2008 6:24 pm

Is there s-video output on a pal snes?
I'd like to know cause I don't wanna build a sync seperator to hook one up to a psone screen.
And I heard the (psone) screen uses the luma from the psone to get sync.
Is this true, and can I therefore use my snes's luma signal (if present) to sync the screen?

Thanks,

Jeroen

phantom92opera · Post by **phantom92opera** » Mon Jul 14, 2008 9:31 pm

http://www.gamesx.com/rgbadd/snes2rgb.htm
much cleaner than svideo

jeroen · Post by **jeroen** » Tue Jul 15, 2008 4:20 am

*sigh* I need c-sync for my psone monitor. I heard you can use luma for this (on a psone monitor) therefore I wanted to know if it has s-video to hook up rgb.

bacteria · Post by **bacteria** » Tue Jul 15, 2008 8:21 am

PAL system: Looking into video connector at rear of console, where right up is "1", right down is "2", across to left bottom being "12":

1 Rgb
2 rGb
4 rgB
5 & 6 ground
7 Luma
8 Chroma
9 Composite
11 audio left
12 audio right

jeroen · Post by **jeroen** » Tue Jul 15, 2008 8:21 am

jeroen wrote:*sigh* I need c-sync for my psone monitor. I heard you can use luma for this (on a psone monitor) therefore I wanted to know if it has s-video to hook up rgb.

edit: plus there is no pal snes2.

phantom92opera · Post by **phantom92opera** » Tue Jul 15, 2008 9:21 am

buy a region modded ntsc?

jeroen · Post by **jeroen** » Tue Jul 15, 2008 9:28 am

(to my knowledge) there is no region mod for the snes2. Plus the snes motherboard aint THAT big.

bacteria · Post by **bacteria** » Tue Jul 15, 2008 8:08 pm

jeroen wrote:
jeroen wrote:*sigh* I need c-sync for my psone monitor. I heard you can use luma for this (on a psone monitor) therefore I wanted to know if it has s-video to hook up rgb.
edit: plus there is no pal snes2.

The standard SNES board is not that big.