Hannspree 9.6" lcd

ptj · Post by **ptj** » Fri Jul 11, 2008 6:29 pm

phantom92opera wrote:...and make sure you screwed in those 2 cables according to their polarity ( red + / black - )

I'm not sure what you meant by that...

OK, using the multimeter I've found that I'm getting 12 volts at the red circle but nothing at the green circle which tells me that something isn't right in the powerboard.

phantom92opera · Post by **phantom92opera** » Fri Jul 11, 2008 9:05 pm

is the power entering at the red? maybe you have a loose wire or cut trace leading to the board with the green spot. the polarity refers to positive voltage and negative (ground)

you said there were 2 "screw" connectors.. were they both black (usually) or was one red because then it needs to be attached to a positive power point

ptj · Post by **ptj** » Fri Jul 11, 2008 10:17 pm

I am getting power through all 6 of the wires that run from the powerboard to mobo.

Sorry for the confusion. There are two sets of wires that come out of the side of the lcd (see bottom left of pic) They plug into the green circle. On the "fcc" cable there is tape wrapped around it with a wire (halfway up on right of pic) that screws to the left of the connection on the mobo.

I wish I knew what I was doing, thanks for the help so far.

phantom92opera · Post by **phantom92opera** » Fri Jul 11, 2008 10:22 pm

do you have aim i could work this out for abt another half hour. its quicker
SN: phantom92opera

szovertoplcd · Post by **szovertoplcd** » Sat Jul 12, 2008 3:19 am

Hope following datasheets center can help you with thelcd panel.

Electric Rain · Post by **Electric Rain** » Mon Jul 14, 2008 2:59 am

GrindcoreKid wrote:
ptj wrote:yeah i'll check that out to see if its possible when i get it
It would be great if you could respond with your findings. I'm currently searching for a good, but large screen to use on a portable project.

http://forums.benheck.com/viewtopic.php?t=19348

phantom92opera · Post by **phantom92opera** » Mon Jul 14, 2008 8:31 am

he has a screen now - its just not working

Electric Rain · Post by **Electric Rain** » Mon Jul 14, 2008 4:05 pm

GrindcoreKid doesn't. That's who the comment was directed towards.

phantom92opera · Post by **phantom92opera** » Mon Jul 14, 2008 4:18 pm

ah - i c

Electric Rain · Post by **Electric Rain** » Mon Jul 14, 2008 4:24 pm

I linked him to that because it's a large, nice (I think, at least) screen that I have documented quite heavily.