Messed up Gamecube pinouts

[ptj]

I found this pinout guide for the Gamecube and started to use it...but then I realized that the picture is 2x12 instead of the actual 2x11. It's even labeled 1-11, 12-22


Where's the mistake?

And I think in kasar said that there are 5 wires between the two, this diagram only shows 4.

[kasar]

I only used gamevelvers info, but I didn´t designed it ^^



here is gamevelver´s post

All right here's a pinout of the power regulator voltages:

first of all here's how the power regulator board looks:


all you really have to worry about are pins 12-22. pin 13 is 3.4v, pins 16-18 are 1.9v, pin 21 is 12v, and pin 22 is 5v. also you have to make sure you have ground.
here's the pins on the GC ( that box with the lines is the heatsink....I suck at paint):


pins 2 and 13 need 3.4v, pins 6,7,16,17,18,19 need 1.9v, pin 10 needs 12v, and pins 11 and 22 need 5v. just make sure that the pins that I've grouped together, like 6, 7, 16, 17, 18, 19 are connected together. they should be, though.

and that's how you only need 5 wires to attach the gc power regulator board to the GC board!!!!!!!!!!!!! that "bit of bad news" was that a gc regulator had fried and so I ordered another one....

* oh yeah if you turn on your GC and you don't get any sound, try getting the 12v not from the pin on the GC power regulator, but directly from the actual GC ac adapter. I also tried that from the 14.8v li-poly battery pack and it worked fine.

this configuration works fine, I´m using it with my project without any problem, I also Got 12v from pin 21 for feed my screen

[ptj]

ok thanks i knew i had seen that beautiful heat sink before i just couldnt find it.

modified diagram:


So where does the ground go then?

[kasar]

So where does the ground go then?

I got ground from pin 1 of the regulator board, you can wire it to the yellow thing bording the gc mobo