Check my COMPLETE diagram please.

Dr. KillGood · Post by **Dr. KillGood** » Sun Jun 01, 2008 5:45 pm

I did not get the yobo to run off batteries yet, so the AV jack is still there.

schmellyfart · Post by **schmellyfart** » Sun Jun 01, 2008 5:49 pm

Dr. KillGood wrote:

Connections look good right?

These pictures disagree

EDIT: You do know that a/v stands for audio/ video, right?

Dr. KillGood · Post by **Dr. KillGood** » Sun Jun 01, 2008 6:34 pm

Well the one I took before I changed a few things.

Sharp Sapphire · Post by **Sharp Sapphire** » Sun Jun 01, 2008 7:21 pm

ok solder the black wire (which should be ground) to the holes next to the yellow or white wires.

Aguiluz · Post by **Aguiluz** » Sun Jun 01, 2008 11:01 pm

Dr. KillGood wrote:Well where does the black wire attach to the YOBO?

From what I can make out from the pics, you can attach the ground to any of these three points:

Can anybody verify it if it is correct?

schmellyfart · Post by **schmellyfart** » Sun Jun 01, 2008 11:11 pm

Aguiluz wrote:
Dr. KillGood wrote:Well where does the black wire attach to the YOBO?
From what I can make out from the pics, you can attach the ground to any of these three points:

Can anybody verify it if it is correct?

Yes, anywhere along that trace.

Dr. KillGood · Post by **Dr. KillGood** » Sun Jun 01, 2008 11:40 pm

*facepalm.gif*

Thanks I am going to go change where the wires are connected!

Dr. KillGood · Post by **Dr. KillGood** » Mon Jun 02, 2008 3:48 am

It is official, the Yobo is dead.

I just found a scratch across some leads right next to the NOAC coverd in black stuff.

Oh well I can go get a FC twin down at Plat N' Trade tomorrow.

Aguiluz · Post by **Aguiluz** » Mon Jun 02, 2008 1:48 pm

Dr. KillGood wrote:It is official, the Yobo is dead.

I just found a scratch across some leads right next to the NOAC coverd in black stuff.

Oh well I can go get a FC twin down at Plat N' Trade tomorrow.

Aw man. Maybe the leads can be repaired by conductive pens?

Edit: Minor spelling fix.