Bawls lamp

gamemasterAS · Post by **gamemasterAS** » Mon Apr 14, 2008 4:13 pm

I'm going to make this Bawls lamp

http://www.instructables.com/id/Bawls-B ... LED-Light/

But I need to know what to use for LEDs, resistors and a power supply.

I was thinking about these for LEDs

http://www.ledshoppe.com/Product/led/LE1015.htm

Post by **bicostp** » Mon Apr 14, 2008 4:34 pm

Right, because everyone needs glowing Bawls.

Here's a calculator to figure out what resistors to use:

http://ledcalc.com/

That's a good price for LEDs, much better than ol' Rat Shack. (Then again, everyone's got better than them.

)

gamemasterAS · Post by **gamemasterAS** » Thu Apr 17, 2008 4:55 am

So if I was using a 9v power supply I would need a 47 ohm resistor?