I had just received two new disk rotors in the mail for my bike (ebay)!
One of the two previously on my bike was bent.
So, as soon as I got home, 2:45PM, I ripped open the package and ran to the shop to install them. I was planning on riding down to the school after I did so.
First ones went on with a little work, adding a couple washers for space. Adjusting the brakes took me about 10 minutes, but I assumed it would take something like that, so no problem.
I installed the rear rotor, a washer for space and it was all good. Messing with the brakes was a female of the dog species. I need to realign the wheel someone soon.
I spun the wheel, then slid the brake system over by pushing on it.
You can see the braking system here...
http://img257.imageshack.us/my.php?imag ... 143kh6.jpg
...and...
http://img519.imageshack.us/my.php?imag ... 144kh4.jpg
3:00PM
So, I went to slide it over, again and the rotor caught my finger...hurts l like hell and makes everyth -- just realized I was getting blood on keyboard as I type, yes this is real time, folks!
Some pictures..remember, I'm using one hand and a right handed camera in my left hand...
http://img187.imageshack.us/my.php?imag ... 132yb2.jpg
http://img187.imageshack.us/my.php?imag ... 136gz3.jpg
http://img519.imageshack.us/my.php?imag ... 140ms2.jpg
http://img519.imageshack.us/my.php?imag ... 141sw5.jpg
I ran inside, washed it out in the sink (
So, comments and questions below...






