SNESp troubleshooting.

Mikeyman64 · Post by **Mikeyman64** » Fri May 18, 2007 10:35 pm

What does it mean when you have all wires connected in a standard SNESp setup (led modded PSOne screen, AA batteries) and you turn it on and all you get is a bright white screen with no video feedback?

Mikeyman64 · Post by **Mikeyman64** » Sun May 20, 2007 2:34 pm

Bump.

Nix that, it was a low batt problem.

Now I'm having trouble with the SNES board. All I get, with all the wire connected to (I'm pretty darn sure) the right spots, is a short little flicker on the screen. That's with the PSOne screen and a normal TV (w/hacked up A/V cable).

Any clue? I really hope it's not a bad/fried SNES because I just spent two days relocating the cart slot

.

Anything would be nice.

THON · Post by **THON** » Sun May 20, 2007 5:04 pm

Do you have a cartridge in? If not, try one, if so, try others. I

Kurt_ · Post by **Kurt_** » Thu May 24, 2007 3:43 pm

Cart slot relocation seems the most likely culprit. Check to make sure all the connections are fine. If any wiggle, resolder them. If any are broken off, well you'll figure something out.

Mikeyman64 · Post by **Mikeyman64** » Thu May 24, 2007 5:14 pm

Kurt_:love the avitar.

I've tried 3 different cartridges (all cleaned by me, they work), and double checked every single wire connection on both ends. I even went as far as smothering them all with hot glue after they were checked.

I'm almost positive I've fried the mobo. I've already ordered another one (found one for $10 with $29 shipping, not bad).

gamefreakfatty · Post by **gamefreakfatty** » Sat Jul 21, 2007 7:15 pm

not sure if this helps, but i read something on Ben's SNESp, and he had the cartridge inserted backwards, but i dont know if he got a white screen, make sure they're in the right way though.