Its a ps1p and i using all the usual gear: psone, psone screen, handmade case.
Basically i started off with an old modem case with i thought would be perfect.After looking at playmad a lot i used a lot of the same techniques he used in the way he made case. Its going to be running off a rc 7.2 battery. Have a av out, phone heads, Second controller. You know the usual.
Front shot above and below a nice angled shot of the case,sorry about the level of light.
After doing some planning and waiting for parts to arrive i got right into it First cutting the ps controller up with my dremel
and then cutting the case. After this was finished i went and got some orange juice and refreshed myself 
Just seeing what things should look like and just thinking how cool it is to be making a psp.
After cleaning the case up a bit i super glued all the button holes in.
After getting to this part i had to go out and buy some more sand paper and putty. i had a look of what everything looked like inside
The psone screen Mbo is sitting in a werid spot and will not be sitting there, it sits a bit over the edge over the case but i am doing something with that
. The grates in like the middle below the screen hole,I am not sure what i am going to do with that. It was going to be for speakers, But there is not room for them there, so i am thinking i am going to cut it all out and replace the area with the plastic that i cut from the screen cut to shape and then sand and putty it till its Not noticeable. I am also painting a colour much like the ps2 colour.At the moment i have puttied most of it, i havn't started the back where the cd drive and the r1 and r2 buttons are, But by next week i plan to have the primer on it.
i will continue to update this topic with whats going on.
But seriously good job man i like the case design you got going there.
