http://benheck.com/phpBB/viewtopic.php? ... highlight=
But when using the exact same Third Party N64 Controller as Electric Rain used, and the C Joystick from a Nintendo Gamecube Controller, I find that the N64 controller MOBO has the pins VX1, VY1, VC1, VD1, and VG1 for the Joystick.
Upon looking at the Third Party N64 joystick, I find that VX1 and VY1 are the power pins, VC1 and VD1 go to the chip (i.e. the middle pin on the potentiometer), and VG1 is ground for both axis.
BUT!!! NO MATTER HOW I WIRE IT TO THE C JOYSTICK! I can only move diagonally from the bottom left to the top right of the screen. It would seem as though a push on either axis potentiometer activates both axis potentiometers.
THEN! I noticed that the POWER pins were separated on the Third Party N64 Controller MOBO but are wired together as one on the Gamecube Joystick so as the GC Joystick has one common power and one common ground whilst the N64 Joystick has separate powers.
I'm sorry if I am rambling too much but can someone verify or disprove my observations? I'm at my wits end and Electric Rains post is to vague to help.
